{"id":16060,"date":"2023-12-29T09:29:05","date_gmt":"2023-12-29T09:29:05","guid":{"rendered":"http:\/\/okeanija.mk\/?post_type=product&p=16060"},"modified":"2023-12-29T13:01:48","modified_gmt":"2023-12-29T13:01:48","slug":"murexin-1k-express-bitumen","status":"publish","type":"product","link":"https:\/\/okeanija.mk\/?product=murexin-1k-express-bitumen","title":{"rendered":"Murexin 1K Express Bitumen"},"content":{"rendered":"

COVER COATING 1K EXPRESS<\/h1>\n
\n
\n
    \n
  • ready for processing<\/span><\/li>\n
  • quick reacting<\/span><\/li>\n
  • sprayable<\/span><\/li>\n<\/ul>\n

    High quality, single-component, polystyrene-filled, quick-reacting, plastic-tempered bitumen cover coating. Indoors and outdoors for manual production of permanent, flexible seals of structures in contact with the ground, in contact with the ground.<\/p>\n

    Material information:<\/p>\n

    – If processing outside the ideal temperature and\/or humidity range the material properties could change markedly.<\/p>\n

    – Bring the materials to the proper temperature before processing!<\/p>\n

    – In order to maintain the product properties, do not add any foreign materials!<\/p>\n

    – Water dosing quantities or dilution information must be strictly adhered to!<\/p>\n

    – Check tinted products for colour accuracy before application!<\/p>\n

    – Colour consistency can only be guaranteed within the same batch.<\/p>\n

    – The colour formation is significantly impacted by the environmental conditions. Environmental information:<\/p>\n

    – Do not process at temperatures below +5 \u00b0C!<\/p>\n

    – The ideal temperature range for the material, substrate and air is + 15 \u00b0C to + 25 \u00b0C.<\/p>\n

    – The ideal relative humidity range is 40% to 60%.<\/p>\n

    -Increased air humidity and\/or lower temperatures may prolong the drying, setting and hardening time, while lower air humidity and\/or higher temper atures will speed it up.<\/p>\n

    – Ensure adequate ventilation during the drying, reaction and hardening phase; avoid draughts!<\/p>\n

    – Protect against direct sunlight, wind and weather!<\/p>\n

    – Protect adjacent components!<\/p>\n