Code: –
Barcode: –
Material basis:   Silicone, acetic acid hardening
Components:   1-component
Consistency:   pasty
Specific weight DIN 52451:   approx. 1.0 g / cm³
Joint width : up to 30 mm
Processing   temperature : +5 ° C to +40 ° C (substrate temperature)

Skin-forming time: approx 10–12 minutes, after a few hours the skin is severely vulnerable
Hardening speed *: approx. 2 mm / day – approx. 7 mm / week
Temperature resistance:   -40 ° C to +180 ° C
Practical elasticity:   approx. 25% of the joint width
E -Module 100%:   approx. 0.40 N / mm² (DIN EN 28339 method A)
Shore A hardness: that. 25

Consumption: 
10 x 10 mm joint approx. 3.0 running meters, per cartridge
5 x 5 mm joint approx. 12.0 running meters, per cartridge
With triangular joints, the consumption is reduced to half the amount.

* At +23 ° C and 50% relative humidity. Higher temperatures and / or higher air humidity shorten the hardening time and increase the hardening speed, lower temperatures and / or lower air humidity extend the hardening time and reduce the hardening speed.
Labeling according to GHS / CLP : see safety data sheet 
Labeling according to ADR: see safety
data sheet Packing:   Cartridge with 310 ml net, packed in 12 and 20 pieces
Storage: Can be stored   in cool and dry rooms for approx. 24 months in the originally closed container

Code: –
Barcode: –

Suitable for External Use or Wet Areas
Yes
Not suitable for swimming pools

Suitable for Use with Under Tile Heating
Yes

Skin Forming Time
5 minutes

Coverage
Approximately 9m per 310ml cartridge with a 6x6mm bead