Scope of application: Inside and outside. Wall and floor. Positioning and laying of:
– Earthenware, stoneware and porcelain stoneware tiles
– Natural stone slabs (insensitive to moisture)
Appearance of:
– suitable building boards, e.g. plasterboard
– Insulation boards made of rigid foam and mineral fibers
– Tile elements (hard foam insulation panels with mortar lamination on both sides)
Gluing of ceiling, sight and sound insulation panels. For laying porcelain stoneware tiles
– on underfloor heating, on balconies and terraces, on facades and in the underwater area with edge lengths> 30 cm
– on shrinking surfaces, e.g. B. Concrete <6 months old, dry screed elements etc., are the MICROTEC flexible adhesives, ARDEX X 78 and ARDEX X 77 to be used.
Type:
Powder with cements, fillers, flexible acting Plastics and additives.
When mixed with water, a smooth, pasty, stable adhesive mortar, which by hydration and Drying hardens and after a few days water and is weatherproof. ARDEX X6 PLUS adheres practically insoluble on all suitable surfaces, such as concrete, Cement screed, calcium sulphate screed, mastic asphalt screed, Plaster, masonry, etc., and provides a permanent connection between the building materials.
Preparation of the subsurface:
ARDEX X6 PLUS adheres to dry and damp Substrate that is firm, stable, non-slip and free of release agents have to be.
Base made of plaster of paris and absorbent or Ground calcium sulfate must be dry and is with ARDEX P51 adhesive and primer dispersion,
Diluted 1: 3 with water, primed.
Gypsum plasters should have a single layer at least 10 mm thick and not be felted and smoothed.
Tile coverings, metal, glass, paintwork, coatings and similar substrates are indoors / dry areas to be primed with ARDEX P82 synthetic resin primer.
Reviews
There are no reviews yet.